![]() Apply one or two layers of the included adhesive mounting tape to the back of the flat mounting bracket, near the bottom (optional).Insert the two camera clip screws into the holes labeled.Rotate the camera clip 180 degrees, so the Garmin logo is facing right-side-up.Using a Phillips screwdriver, fully loosen the two camera clip screws, and remove the camera clip from the metal bracket.This allows you to properly adjust the camera angle. When installing the camera at the bottom of your license plate, you must remove, rotate, and reattach the camera clip. Out of the box, the camera mount is assembled for installing the camera at the top of your license plate. To allow for proper camera angle adjustment, the Garmin® logo on the camera clip must be right-side up when the mount is installed on your vehicle. Installing the Camera at the Bottom of Your License Plate Install license plate screws through the bottom holes of the license plate, and tighten (optional).This option is not available for all vehicles or for all mounting bracket positions.Fully tighten the license plate screws.Insert the license plate screws through the top of the license plate and mount, and into the license plate mounting holes on your vehicle.It is your responsibility to follow license plate mounting regulations. Some jurisdictions prohibit covering any portion of the license plate. ![]() You must avoid covering any text or numbers on the license plate. You should use the mounting position that fits your vehicle and covers the smallest portion of the license plate.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |